Apple Ethernet CS Twisted-Pair Card Guide de l'utilisateur

KApple Ethernet CS Twisted-Pair Card User’s Guide

85. If you see the following dialog box, click OK.If you don’t see a dialog box, skip to step 6.If your network has been set up to allow you to choos

9TroubleshootingThe first step in troubleshooting any problem with yournetwork connection is to check that the card’s green LEDlight is on—if your car

If you can’t select EtherTalk in the Network control panel: Be sure that the network cable is properly attached andthat the card’s green LED is on. If

11SpecificationsConnector Ethernet 10BASE-T–compliant RJ-45 portRecommended cable Category 3, 26 gauge;100 meters from card to hub, maximum Ethernet t

030-5461-A

FCC statementThis equipment has been tested and found to comply with thelimits for a Class A digital device pursuant to Part 15 of theFederal Communic

This manual is copyrighted by Apple or by Apple’s suppliers, with allrights reserved. Under the copyright laws, this manual may not becopied, in whole

About this communications cardThe Apple Ethernet CS Twisted-Pair Card expands thecommunications capabilities of models of Macintoshcomputers that have

Installing and connecting your card1. Follow the specific setup information thatcame with your Macintosh to open the backpanel or lid, and locate the

4. Follow the directions that came with yourcomputer and replace the back panel or lid,and reattach any cables you removed earlier. Depending on the m

Installing EtherTalk software To install the correct version of EtherTalk software youneed to use the Installer program on the Network SoftwareInstall

2. Open the Installer program, review theWelcome screen, and click OK. 3. Make sure that the disk indicated on theInstaller’s dialog box is your cur

Setting the Network control panel forEtherTalkA Macintosh computer’s network connection is preset forLocalTalk. To connect to an Ethernet network inst