Apple QuickTake 200 Camera Guide de l'utilisateur télécharger pdf (Page 11)

Charging the batteries

The three NiCad batteries you received with the QuickTake 100 must be

charged before you can use them. Use the battery charger that came with the

camera.

1 Insert the batteries into the charger.

2 Plug the battery charger into an electrical outlet.

It takes five hours to fully charge three NiCad batteries. (Be sure to fully

charge the batteries the first time you use them.) If you want to take pictures

right away, you can use three AA non-rechargeable batteries (not included) in

the camera. For information about battery care, see Appendix B.

3 Unplug the battery charger, remove the batteries, and install them in the camera.

See instructions for installing batteries on the next page.

WARNING

To reduce the risk of injury, charge only rechargeable nickel-

cadmium batteries in the battery charger that came with the QuickTake

100 camera. Charging other types of batteries may cause them to leak or

explode, resulting in personal injury and property damage.

Make sure you position the

and –

ends of each battery as indicated on

the battery charger.

When batteries are charging, this

red light glows.

Chapter 1

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 78 79

Pas de commentaire

Apple QuickTake 200 Camera Guide de l'utilisateur Page 11