Apple Xserve RAID User's guide Guide d'installation télécharger pdf (Page 15)

15Chapter 1 Installing the Xserve

Â If you have a threaded-hole rack, start with the rail anges outside the rack posts and

compress the rail into position.

Position the spacer

over the threaded guide

on the rail assembly.

This end is up.

Compress the rails

so that they fit on the

outside of the rack posts.

Use either eight 10-32 or eight

M5 screws (supplied), depending on

which type your rack requires.

2 Slide a spacer, with the arrow up, over the small round guide at the ends of each rail

and install the mounting screws nger tight.

Don’t tighten the mounting screws until you align the rails in the next step.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 59 60

Pas de commentaire

Apple Xserve RAID User's guide Guide d'installation Page 15