Apple 8550 Spécifications télécharger pdf (Page 48)

9 Replace the cover on the server.

Lower the cover all the way down onto the case. Push the cover toward the

back until it touches the back panel.

10 Tighten the screws on the back panel.

You are now finished installing the card. If a software driver was included

with your expansion card (on a floppy disk), after you finish setting up your

server and turn it on, you will need to install the driver.

Return to Chapter 1 to complete the steps for setting up and turning on your

server, and then, if you need to install driver software, refer to the

documentation that accompanied the expansion card and to “Installing

Device Drivers” in Chapter 1 of the Wo r k gr oup Server Administrator’s Guide.

WARNING

Never turn on your server unless all of its internal and

external parts are in place. Operating the server when it is open or

missing parts can be dangerous, and can damage your server.

Installing an expansion card 39

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 120 121

Pas de commentaire

Apple 8550 Spécifications Page 48