Apple Newton Connection Utilities Manuel d'utilisateur télécharger pdf (Page 10)

Preparing your Newton device

Before you use the Newton Connection Utilities, you need to tell your

Newton device how it is connected to the computer.

IMPORTANT

Make sure you enter your name and other owner information on

your Newton device. The computer uses this name when it creates a backup

file. See your Newton user’s manual to learn how to enter your name. Also, it’s

a good idea to name the storage cards you use with your Newton device.

Selecting the type of connection on your Newton device

1 On your Newton screen, tap Dock.

Note: On some Newton devices, Dock is called Connection. To open it, first

open the Extras drawer ´, tap the Extras folder tab, tap All Icons, then tap

Connection (or Dock k). If you’re using the eMate 300, you can customize

the Dock key on the keyboard so that it opens Dock. See the documentation

that came with your eMate for instructions.

A slip appears showing the type of connection currently set for your

Newton device.

2 If the type of connection that appears in the slip is not correct, tap “Connect via” to

change the type of connection.

A list of connection types appears.

If you choose Serial, your connection setup is complete. Skip to the next

section, “Establishing a Connection.” If you choose AppleTalk, continue with

step 3.

Chapter 1

Tap to select another

type of connection.

Shows the type of connection

set for your Newton device

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 116 117

Pas de commentaire

Apple Newton Connection Utilities Manuel d'utilisateur Page 10