Apple Xserve (Early 2008) DIY Procedure for Logic Board Manuel d'utilisateur télécharger pdf (Page 22)

Xserve (Late 2006/Early 2008) Logic Board Replacement Instructions 22

Replacing the Processors

Unsnap the protective plastic cover from the rst processor holder on the replacement logic 1.

board, unclip the holder latch, and open the holder.

Plastic protective cover

Holder latchProcessor holder

Using a syringe of thermal grease, apply the entire contents of the syringe (approximately 4.5 2.

cc) to the top surface of the processor.

Important: Be sure not to get grease anywhere on the processor other than the very top, at

surface that directly contacts the heat sink.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 30 31

Pas de commentaire

Apple Xserve (Early 2008) DIY Procedure for Logic Board Manuel d'utilisateur Page 22