Apple Xserve (Early 2008) DIY Procedure for Xserve RAID Manuel d'utilisateur télécharger pdf (Page 5)

073-1151 Rev. B 5

Caution: The power distribution board cable connectors are tight and can be dicult to

disconnect. You may want to use a small atblade screwdriver to gently yet rmly pry outwards

on the cable connector while depressing the cable connector latch with your thumb and

forenger to separate the connectors.

Airow Duct

Loosen the ve Phillips screws that fasten the airow duct to the fan array.1.

Pull up on either side of the airow duct, and lift it straight up and out of the Xserve. 2.

Caution: Try not to completely remove the screws from the airow duct. Tiny black rubber

washers hold these screws captive on the underside of the airow duct. If the screws are

completely removed, these washers can easily fall into the enclosure and become lost.

1 2 3 4 5 6 7 8 9 10 ... 15 16

Pas de commentaire

Apple Xserve (Early 2008) DIY Procedure for Xserve RAID Manuel d'utilisateur Page 5