Apple Xserve Intel (Late 2006) DIY Procedure for Heatsin Manuel d'utilisateur télécharger pdf (Page 10)

Xserve (Late 2006) Processor Heat Sink Replacement Instructions 10

Replacing the Airow Duct

Lower the airow duct into position on the logic board.

Note: When installing the airow duct, be sure to route both the front panel board cable and

the backplane-to-logic board I/O cable inside the channel under the left side of the duct.

Ensure the airow duct ts ush all over, and does not protrude above the enclosure.

Note: Be careful when working with any black foam pieces that are part of the airow duct

or the logic board.

Tighten the ve Phillips screws that fasten the airow duct to the fan array, in the order

shown, to prevent the duct from warping. Do not overtighten the screws.

1 2 ... 5 6 7 8 9 10 11

Pas de commentaire

Apple Xserve Intel (Late 2006) DIY Procedure for Heatsin Manuel d'utilisateur Page 10