Apple Xserve Intel (Late 2006) DIY Procedure for Rear ID Manuel d'utilisateur télécharger pdf (Page 10)

Xserve (Late 2006) Rear ID Tab Replacement Instructions 10

Disconnect the optical drive cable from the logic board.

Release the two locking levers on the front panel board cable connector and disconnect the

cable from the logic board. Move the cable aside so you have access to the logic board.

Loosen the single thumbscrew on the power distribution board and slide the board away

from and out of the connector on the logic board.

Note: Don’t remove the power distribution board but make sure its edge connector is all the

way out of the connector on the logic board.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 21 22

Pas de commentaire

Apple Xserve Intel (Late 2006) DIY Procedure for Rear ID Manuel d'utilisateur Page 10