Apple Xserve Intel (Late 2006) DIY Procedure for Thermal Manuel d'utilisateur télécharger pdf (Page 8)

Xserve (Late 2006) Thermal Grease Kit Instructions 8

Rotate the top of the holder to the closed position.

Engage the latch on the processor holder.

Repeat steps 1–9 for the second processor.

Installing the Processor Heat Sinks

Important: Before re-installing each heat sink, be sure to clean o any existing thermal grease

from the underside of the heat sink.

Holding the heat sink in one hand, reconnect the 2-pin thermal sensor cable for the left

processor (CPU B) heat sink to the logic board.

Note: Make sure the connector on the sensor cable is oriented as illustrated, with the gold

ngers facing up.

10.

1 2 3 4 5 6 7 8 9 10

Pas de commentaire

Apple Xserve Intel (Late 2006) DIY Procedure for Thermal Manuel d'utilisateur Page 8