Apple Xserve RAID: Using RAID 1.2 Admin and Disk Utility Manuel d'utilisateur télécharger pdf (Page 12)

12 Chapter 1

Configuring an Xserve RAID System

Network Address

You use the Network pane of the Settings window to set the IP address for each RAID

controller in the system.

•

If you have one or two static IP addresses, choose Manually from the Configure pop-

up menu and type the address, subnet mask, and router information.

•

If you don’t have a static IP address, choose Using DHCP from the Configure pop-up

menu. (DHCP is the default setting for the system.)

For specific information about the IP address and other network details for your system,

check with the network administrator at your location.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 42 43

Pas de commentaire

Apple Xserve RAID: Using RAID 1.2 Admin and Disk Utility Manuel d'utilisateur Page 12