Apple Power Macintosh 8500/150 Series Manuel d'utilisateur télécharger pdf (Page 111)

How to initialize a hard disk

You initialize an Apple SCSI hard disk by using a program called

Drive Setup, which is on the floppy disk labeled Disk Tools that came with

your computer. If your computer came with a CD-ROM drive and you didn’t

receive floppy disks, you can find Drive Setup on the CD-ROM disc that

contains system software. (To initialize a hard disk from another

manufacturer, use the utility software that came with the hard disk.)

1 Start up your computer from the

Disk Tools

disk or the CD-ROM disc that contains

system software.

See “Starting Up From a CD-ROM Disc” or “Starting Up From a Floppy

Disk” earlier in this section.

2 Open the Drive Setup icon.

You may need to look in a folder called Utilities to find Drive Setup.

3 In the list of drives, click the disk you want to initialize.

4Click Initialize to initialize the hard disk.

5Click Quit when you see a message reporting that initialization was successful.

If a message reports that initialization failed, try again. If initialization

fails a second time, take the disk to your Apple-authorized service provider

for repair.

111

Troubleshooting

Click the drive you

want to initialize...

...then click Initialize.

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 179 180

Pas de commentaire

Apple Power Macintosh 8500/150 Series Manuel d'utilisateur Page 111