Apple Xserve G5 Spécifications télécharger pdf (Page 39)

Note: Pin eleven supports the drive activity light. For full functionality of the drive activity light and

system monitoring, use Apple drives. Other drives are not supported.

The drives on the independent Serial ATA buses implement revision one ports. For references to

SATA website information, refer to “Serial ATA” (page 48).

Each drive carrier has two LEDs. The top one is a multicolor LED indicating drive state as follows:

■

Green: Drive in normal use by system

■

Yellow: Drive changing state (spinning up or down) or pre-failure warning

■

Red: Drive has failed

■

No color: No power to drive

The bottom (blue) LED indicates the individual drive’s disk activity.

The monitoring software supports only drive modules manufactured by Apple.

VGA Connector

As a build-to-order option, the Xserve G5 slot load can have a video graphics card installed in Bus B

of the PCI-X bridge. The card has a VGA connector for the video monitor.

The VGA connector is a three-row DB-15 (also called mini sub D15) connector for use with a VGA,

SVGA, or XGA monitor. Figure 3-5 (page 39) shows the pin configuration and Table 3-9 (page 39)

lists the signals and pin assignments.

Figure 3-5 VGA connector

1 2 3 4 5

6 7 8 9 10

11 12 13 14 15

Table 3-9 Signals on the VGA connector

DescriptionSignal namePin

Red video signalRED1

Green video signalGREEN2

Blue video signalBLUE3

No connectn.c.4

GroundGND5

Red video signal returnRED_RTN6

VGA Connector 39

CHAPTER 3

Input and Output Devices

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 56 57

Pas de commentaire

Apple Xserve G5 Spécifications Page 39