Apple LaserWriter Pro 600 Envelope Feeder Guide de l'utilisateur Page 151

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 260
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 150
EN
Chapter 4: Problem Solving 129
Troubleshooting HP Fast InfraRed
Receiver Problems
Troubleshooting HP Fast InfraRed Receiver Problems
Item Explanation
FIR port status
indicator does not
light up.
Make sure that the printer is in
READY
mode and that the FIR port
you are printing from is IRDA-compliant and within the range of
operation described in the user guide for the HP Fast InfraRed
Receiver.
Make sure that the HP Fast InfraRed Receiver is properly connected
to the printer.
Print a configuration page (see page 134). Make sure that “FIR POD
(IRDA Compliant)” is printed under Installed Personalities and
Options.
Connection cannot be
established or seems to
take longer than usual.
Use a device that is IRDA-compliant; look for an IRDA symbol on
the device or see the computer’s user guide for IRDA specifications.
Make sure that the operating system on your computer includes an
FIR driver and your application uses an HP LaserJet 4050, 4050 N,
4050 T, 4050 TN, or compatible driver. (Note that complex pages
take longer to print.)
Position the HP Fast InfraRed Receiver within the range of operation
described in the user guide for the HP Fast InfraRed Receiver. Make
sure that no object is blocking the connection. (This object could be
a hand, paper, books, or even bright light.)
Make sure that the two IR ports are clean (free from dirt and grease).
Bright light of any kind (sunlight, incandescent light, fluorescent
light, or light from an infrared remote control, such as those used
for TVs and VCRs) shining directly into one of the IR ports might
cause interference. Make sure that no bright light is shining directly
into either IR port.
Position the portable device closer to the FIR port on the printer.
The printer prints only
part of a page or
document.
The connection has been broken during transmission. If you move
the portable device during transmission, the connection can be
broken. IRDA-compliant devices are designed to recover from
temporary connection interruptions. You have up to 40 seconds to
re-establish the connection (depending on the portable device
being used).
The print job has been
properly sent, but the
printer will not print.
If the connection is broken before the entire print job has been
transmitted to the printer (printing has not yet started), the printer
may not print any of the job. Press
[Cancel Job]
to clear the printer’s
memory. Then, reposition the portable device within the range of
operation described in the user guide for the HP Fast InfraRed
Receiver, and print the job again.
Vue de la page 150
1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 259 260

Commentaires sur ces manuels

Pas de commentaire