Apple LaserWriter Pro 600 Envelope Feeder Guide de l'utilisateur télécharger pdf (Page 230)

C-6 Printer Memory and Expansion

Adjusting Memory Settings

Resource Saving

Resource Saving allows the printer to keep downloaded resources

(permanent downloaded fonts, macros, or patterns) in memory

when the printer language or resolution is changed.

If you do not have an optional hard disk or flash DIMM for storing

downloaded resources, you might want to change the amount of

memory allocated to each language when downloading an

unusually large number of fonts, or if the printer is in a shared

environment.

The minimum amount of memory that can be allocated to Resource

Saving is 400 KB each for PCL and PS.

To determine how much memory to allocate to a language:

1 From the Configuration Menu, set

RESOURCE SAVE=ON

(page B-15). You might need to add memory to the printer in order

for this option to appear in the printer’s control panel.

2 Also from the Configuration Menu, choose either

PCL MEMORY

PS MEMORY

and change the setting to the highest value displayed.

This amount will vary depending upon how much memory is

installed in the printer.

3 Using a software application, download all the fonts you want to

use in the selected language.

4 Print a configuration page (page 134). The amount of memory

used by the fonts is listed next to the language. Round this figure

up to the nearest 100 KB. (For example, if 475 KB are shown,

500 KB should be reserved.)

5 From the Configuration Menu, set

PCL MEMORY

PS MEMORY

the value determined in step 4.

6 Repeat step 3. (You must download all fonts again. See the note

below.)

Note When you change the Resource Saving setting, all downloaded

resources (such as fonts or macros) will need to be downloaded

again, unless they are stored on an optional hard disk or flash

DIMM.

1 2 ... 225 226 227 228 229 230 231 232 233 234 235 ... 259 260

Pas de commentaire

Apple LaserWriter Pro 600 Envelope Feeder Guide de l'utilisateur Page 230