Apple Ethernet CS Twisted-Pair Card Guide d'installation télécharger pdf (Page 19)

Installing Asanté MacCon Cards 2-9

Installing a MacCon LC Card

If you have a Macintosh LC, LCII, or Color Classic computer, use the

MacCon LCIII or MacCon-i LC card to connect the Macintosh to the

Ethernet.

Caution

Only the LC and LCII computers can accept FPUs on the LC card. If

your Macintosh already has a math co-processor (or FPU), do not

install the Asanté math co-processor option with the card.

Refer to your Macintosh User’s Guide for illustrated instructions for

opening your computer.

∆

Note: LCIII card

—You can disable link integrity on the Mac-

Con LCIII card by setting the JP2 jumper as indicated in Figure

2-8. (For example, hubs made before the 10BaseT speciﬁca-

tions were published do not support link integrity.)

Figure 2-8

Disabling link integrity, LCIII card

To install the MacCon LC card into the expansion slot on the moth-

erboard, perform the following steps:

Power down the Macintosh. Disconnect and remove the

power cable.

Open the Macintosh.

Make sure you are grounded: check that your anti-static

wrist strap is properly attached to your wrist and to the

Macintosh chassis.

Insert the card into the expansion slot.

JP2

disabled

enabled

JP2–link integrity

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 64 65

Pas de commentaire

Apple Ethernet CS Twisted-Pair Card Guide d'installation Page 19