Apple Ethernet CS Twisted-Pair Card Guide d'installation télécharger pdf (Page 26)

2-16 Installing Asanté MacCon Cards

Installing in a Macintosh IIsi

To install the MacCon+ 30 or a MacCon3 IIsi in a Macintosh IIsi, per-

form the following steps:

Caution

Be very careful when you open the case and work inside the Mac-

intosh IIsi.

Refer to your Macintosh User’s Guide for an illustrated description of

how to open your computer.

1 Power down the Macintosh. Disconnect and remove the

power cable.

2 Open the Macintosh and remove the access port cover.

3 Make sure you are grounded: check that your anti-static

wrist strap is properly attached to your wrist and to the

Macintosh chassis.

4 Plug the controller card into the expansion slot on the

motherboard.

5 Install the daughter card:

— Remove the screws on the daughter card bracket.

— Align the bracket so that the daughter card extends

down from the access port and the external cable con-

nectors protrude through the port.

— Secure the bracket with the screws.

6 Connect the controller card and daughter card:

— Attach the ribbon cable from the daughter card to the

controller card (see Figure 2-12).

Caution

Make sure the white dot on the ribbon cable aligns with the

white dot on the connector.

7 Close the Macintosh IIsi.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 64 65

Pas de commentaire

Apple Ethernet CS Twisted-Pair Card Guide d'installation Page 26