Apple Logic (1.1) Manuel d'utilisateur télécharger pdf (Page 79)

Chapter 7 Mixer, Instruments, and Effects 79

Handling Lines

Lines are created automatically between nodes. The following node functions are

pertinent to lines.

• a short click on, or just outside, a line (not on an existing node) will add a new node

on the line.

• a long click on a line allows you to move the line, along with its two endpoints—the

nodes that encompass the line.

• a long click outside a line will create and select a new node, allowing you to move

this new node immediately.

Curves

There may be occasions where you wish to create non-linear automation data.

• Linear means a straight line.

• Non-linear means curved.

Click-holding on a line or a selection (of several lines and/or nodes), with Command-

Control depressed, allows you to set various curves on a line or the current selection.

Various automation curves

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 132 133

Pas de commentaire

Apple Logic (1.1) Manuel d'utilisateur Page 79