Apple Mac OS X Server Migration For Version 10.3 or Later Manuel d'utilisateur Page 24

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 57
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 23
24 Chapter 1 Mail Service Setup
Relaying SMTP Mail Through Another Server
Rather than delivering outgoing mail directly to its various destinations, your SMTP
mail service can relay outgoing mail to another server.
Normally, when an SMTP server receives a message addressed to a remote recipient, it
will attempt to send that message directly to that server or the server specified in the
MX record, if it exists. Depending on your network setup, this method of mail transport
may not be desired or even possible. You may then need to relay all outbound
messages through a specific server.
You may need to use this method to deliver outgoing mail through your
organizations firewall set up by your organization. In this case, your organization will
designate a particular server for relaying mail through the firewall.
You may find this method useful if your server has slow or intermittent connections
to the Internet.
To relay SMTP mail through another server:
1 In Server Admin, select Mail in the Computers & Services pane.
2 Click Settings.
3 Select the Advanced tab.
4 Click the General tab.
5 Click “Relay all SMTP mail through this host” and enter the DNS name or IP address of
the server that provides SMTP relay.
6 Click Save.
Supporting Mail Users
This section discusses mail settings in your server’s user accounts and mail service
settings in email client software.
Configuring Mail Settings for User Accounts
To make mail service available to users, you must configure mail settings in your user
accounts. For each user, you need to enable mail service, enter the DNS name or IP
address of your mail server, and select the protocols for retrieving incoming mail (POP,
IMAP, or both). You can also set a quota on disk space available for storing a users mail.
You configure these settings with the Workgroup Manager application. For instructions,
see the user management guide.
LL2349.Book Page 24 Friday, August 22, 2003 2:47 PM
Vue de la page 23
1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 56 57

Commentaires sur ces manuels

Pas de commentaire