Apple Xserve (Early 2008) DIY Procedure for Drive Interc Manuel d'utilisateur télécharger pdf (Page 3)

Xserve (Late 2006/Early 2008) Drive Interconnect Backplane Replacement Instructions 3

Removing the Installed Drive Interconnect Backplane

Note: Before removing the power distribution board, you must remove the following:

All Apple drive modules•

Airow duct•

Fan array•

Apple Drive Modules

Press the handle on the front of the drive module so that the handle pops out. Then grasp 1.

the drive handle, and pull the drive module out of the Xserve.

Repeat for all other installed drive modules.2.

1 2 3 4 5 6 7 8 ... 11 12

Pas de commentaire

Apple Xserve (Early 2008) DIY Procedure for Drive Interc Manuel d'utilisateur Page 3