Apple Xserve Intel (Late 2006) DIY Procedure for FB-DIMM Manuel d'utilisateur télécharger pdf (Page 4)

Xserve (Late 2006) FB-DIMM Memory Replacement Instructions 4

Opening the Xserve

Loosen the thumbscrews at the back of the top cover and slide the cover back and up to remove

it. If you have diculty removing the cover, check the enclosure lock on the front panel.

Warning: Even after you shut down the Xserve, its internal components can be very hot. Let

it cool before you open it.

Important: To minimize the possibility of damage to Xserve components due to static discharge,

wear an antistatic wrist strap, if possible, while you work inside the Xserve.

Unscrew the two

captive thumbscrews.

Slide the cover back and lift it off.

Removing the Installed FB-DIMM

Push down the ejectors on the FB-DIMM slot.

Holding the FB-DIMM by both top corners, lift it straight up out of the Xserve.

ConnectorsNotchEjectors

Warning: When removing or installing the DIMM, handle it only by the edges. Do not touch

its connectors. Lift the DIMM straight up from the connector to remove it, and insert it

straight down into the connector to install it. Do not rock the DIMM from side to side.

1 2 3 4 5 6

Pas de commentaire

Apple Xserve Intel (Late 2006) DIY Procedure for FB-DIMM Manuel d'utilisateur Page 4