Apple Setting Up Your Power Macintosh G4 (PCI & AGP) Manuel d'utilisateur télécharger pdf (Page 45)

Working Inside the Computer 45

6 To replace the carrier and drive, align the tabs on the rear of the carrier with the slots in the

computer chassis and slide the carrier in.

7 Reinsert the low-proﬁle attachment screw in each carrier you replace.

Use the screw you removed in step 3.

Slide the hard disk drive into the

computer at an angle, and lower

it into position. Make sure the

two tabs on the underside of the

drive carrier engage the slots on

the floor of the computer.

Install the

attachment screw

to secure the drive carrier.

If you are installing hard

disk drives in drive positions

1 and 2, you must install the

drive in position 1 before you

install the drive in position 2.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 61 62

Pas de commentaire

Apple Setting Up Your Power Macintosh G4 (PCI & AGP) Manuel d'utilisateur Page 45