Apple Xserve (Drive Interconnect Board Replacement) Manuel d'utilisateur

073-0673 Rev. C  Xserve Drive Interconnect Board Replacement Instructions Follow the instructions in this sheet carefully. Failure to follow these

Xserve Drive Interconnect Board - 10 5. Reconnect the ATA controller board to the drive interconnect and logic boards. Note: When replacing the ATA

Xserve Drive Interconnect Board - 11 7. If you removed it earlier, replace the heatsink duct on the heatsink.8. Reinstall the blowers.9. Reinstall t

Xserve Drive Interconnect Board - 2 4. If the server is in the locked position (the yellow security LED on the front panel is on), use the Allen key

Xserve Drive Interconnect Board - 3 9. Grasp the thumbscrews and slide the bottom housing forward part way to expose the two chassis levers. (Figur

Xserve Drive Interconnect Board - 4 For each installed drive, do the following:1. Press the handle on the front of the drive module so the handle po

Xserve Drive Interconnect Board - 5 Blowers 1. Disconnect the cable for the right blower from the drive interconnect board. (Figure 5) 2. Lift the

Xserve Drive Interconnect Board - 6 Heatsink Duct Note: There are two versions of Xserve. If your version does not include a plastic duct over the

Xserve Drive Interconnect Board - 7 ATA Controller Board 1. Press in on both ends of the clip securing the right side of the ATA controller board an

Xserve Drive Interconnect Board - 8 Drive Interconnect Board 1. Disconnect the following cables from the drive interconnect board: (Figure 8) • opt

Xserve Drive Interconnect Board - 9 Installing the Replacement Drive Interconnect Board 1. Install the replacement drive interconnect board on the t