Apple Xserve G5 Guide de l'utilisateur télécharger pdf (Page 10)

10 Chapter 1

Installing Your Xserve G5 PCI Hardware RAID Card

Locate the battery (at the lower-right side of the card) and carefully plug the battery

cable into its connector (beside the battery) on the card.

Note:

The battery cable’s connector only fits one way into the connector on the card.

Turn the card over and align the card's connector with the expansion slot in the riser

and carefully press it into the slot until the connector is inserted all the way into the

slot.

If the card doesn't line up with the “fence” on the back panel, it is not installed

correctly. Press the card gently but firmly until the connector is fully inserted.

•

Don't rock the card from side to side; instead, press the card straight into the slot.

Battery

Plug the battery cable into this connector on the card

The plug will fit into the connector only one way.

Attach the PCI Hardware RAID Card to the PCI riser by pushing it in sideways.

Be sure to engage the card in the slot on the back panel.

PCI Hardware RAID Card

PCI riser

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Pas de commentaire

Apple Xserve G5 Guide de l'utilisateur Page 10