Apple Xserve G5 Guide de l'utilisateur télécharger pdf (Page 11)

Chapter 1

Installing Your Xserve G5 PCI Hardware RAID Card

•

Don't force the card. If you meet a lot of resistance, pull the card out. Check the

connector and the slot for damage or obstruction, then try inserting the card again.

•

Pull the card gently to see if it is properly seated. If it resists and stays in place, and if

its gold connectors are barely visible, the card is connected.

Prepare to install the standoff support piece to connect the card’s corner to the bottom

of the chassis. Mark the position of the standoff on the server’s black mylar insulation.

Attach the plastic standoff to the card as shown without removing the paper

covering on the bottom of the standoff’s base. The standoff passes through the

hole in the corner of the card. You will remove the paper covering on the standoff’s

base later to reveal sticky tape.

With your fingernail or a small blunt instrument mark the position of the standoff

on the black plastic sheet underneath it. The mark should only be temporary.

You are indicating the position for the double-stick tape square that will go

under the plastic sheet to secure it.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

Pas de commentaire

Apple Xserve G5 Guide de l'utilisateur Page 11