Apple Processor Cage and Clips Guide d'installation télécharger pdf (Page 43)

Installing the Service Processor in the Storage System

The HP 3PAR Service Processor consists of the following:

• A standard HP Server

• A 1U Rail Kit for that specific server

NOTE: The SP ID is the HP 7-digit serial number of the array located on the top front of the server

and in a pull-out placard in the front of the server. The serial number is preceded by SP000. For

example, if the 3PAR serial number is 1614983, enter SP0001614983.

Use these procedures when installing the HP 3PAR Service Processor into an existing rack. Before

you begin, verify that you have the proper service processor 1U Mounting Kit (PN 683811-001).

The service processor rail kit supports a variety of products in round, square, or threaded-hole

racks. The following table identifies any tools required for each type of rack.

Table 4 Rack Types

PictureTools RequiredRack Type

NoneRound hole

NoneSquare hole

ScrewdriverThreaded hole

The following components are included in the kit:

• Slide mounting rails

• Screws

• Cage nuts (for the round-hole rack)

• Cable management straps

• Labels

Installing the Service Processor in the Storage System 43

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 116 117

Pas de commentaire

Apple Processor Cage and Clips Guide d'installation Page 43