Apple Processor Cage and Clips Guide d'installation Page 76

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 117
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 75
Figure 50 Generating SP ID Page
NOTE: During the SP Setup process, the StoreServ must be powered on, connected to the
same network subnet as the SP, and non-initialized to allow the SP to verify the StoreServ
serial number.
3. After the SP ID is generated, click Next.
Configure SP Networking
To complete this section, use the completed installation checklist from HP 3PAR StoreServ 7000
Site Planning Manual as reference.
NOTE: For additional information and help, use the HP 3PAR SmartStart online help (accessible
by pressing F1).
1. Enter the SP information for the following fields:
Service Processor hostname
IP Address
Subnet Mask
Gateway
76 Setting Up the Service Processor and Storage System
Vue de la page 75
1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 116 117

Commentaires sur ces manuels

Pas de commentaire