Apple Xserve (Early 2008) DIY Procedure for Enclosure Manuel d'utilisateur télécharger pdf (Page 145)

Xserve (Late 2006/Early 2008) Rear ID Tab Replacement Instructions 4

PCI Riser Cards and Expansion Cards

Loosen the two captive screws that secure the riser bracket in slot 1 to the back panel.1.

Carefully pull up on the bracket and riser, with the expansion card still attached, to 2.

disconnect the riser from the logic board.

Captive screws

Tilt the expansion card up so that its port clears the enclosure, and remove the card from the 3.

Xserve.

Repeat for the riser card in slot 2. 4.

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 168 169

Pas de commentaire

Apple Xserve (Early 2008) DIY Procedure for Enclosure Manuel d'utilisateur Page 145