Apple Xserve (Early 2008) DIY Procedure for Enclosure Manuel d'utilisateur télécharger pdf (Page 45)

Xserve (Late 2006/Early 2008) Backplane-to-Logic Board Cable Instructions 6

Replacing the Airow Duct

Lower the airow duct into position on the logic board. 1.

Note: When installing the airow duct, be sure to route both the front panel board cable and

the backplane-to-logic board I/O cable inside the channel under the left side of the duct.

Ensure the airow duct ts ush and does not protrude above the level of the enclosure. 2.

Note: Be careful when working with any black foam pieces that are part of the airow duct

or the logic board.

Tighten the ve Phillips screws that fasten the airow duct to the fan array, in the order 3.

shown, to prevent the duct from warping. Do not overtighten the screws.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 168 169

Pas de commentaire

Apple Xserve (Early 2008) DIY Procedure for Enclosure Manuel d'utilisateur Page 45