Apple Xserve (Early 2008) DIY Procedure for Enclosure Manuel d'utilisateur télécharger pdf (Page 165)

Xserve (Late 2006/Early 2008) Rear ID Tab Replacement Instructions 24

Carefully seat the heat sink over the processor, aligning the four screws with the holes in the 11 .

logic board.

Tighten the four captive Phillips mounting screws for the heat sink in the order indicated 12.

below. Do not over-tighten the screws. If you have a torque driver, tighten the screws to 8

inch-pounds; otherwise, try to tighten the screws with equal pressure.

Replacing the Backplane-to-Logic Board I/O Cable

Fold the replacement cable to a 90-degree angle along its creases. 1.

1 2 ... 160 161 162 163 164 165 166 167 168 169

Pas de commentaire

Apple Xserve (Early 2008) DIY Procedure for Enclosure Manuel d'utilisateur Page 165