Apple Xserve (Early 2008) DIY Procedure for Enclosure Manuel d'utilisateur Page 160
- Page / 169
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
Xserve (Late 2006/Early 2008) Rear ID Tab Replacement Instructions 19
Following the order shown, use a screwdriver to tighten, but not overtighten, the nine 2.
thumbscrews that secure the logic board to the enclosure.
Slide the power distribution board back into place and tighten the thumbscrew. 3.
Note: Make sure the edge connector on the power distribution board goes completely into
the connector on the logic board. If the power distribution board doesn’t slide easily, make
sure the thumbscrew is popped up so it doesn’t catch on the mounting post beneath the
board.
Reconnect the front panel board cable and the optical drive cable to the logic board.4.
Replacing the Processor Heat Sinks
Note: You will need to clean o the old thermal grease from the bottom of each heat sink and
the top of each processor. You will then need to apply new thermal grease to the top of each
processor, before re-installing the heat sink onto the processor.
Clean o any existing thermal grease on the heat sink using the alcohol wipes provided with 1.
the thermal grease. Keep the package that the wipes came in for use later.
Release the latch on the metal processor holder for the processor.2.
- Enclosure 1
- Replacing the Enclosure 3
- Slide the power supply in and 6
- Hard Drive 7
- Formatting the Hard Drive 9
- Optical Drive 10
- Opening the Xserve 11
- Unscrew the two 12
- Closing the Server 13
- PCI Expansion Card Riser 15
- Tools Required 16
- PCI card 18
- PCI riser 18
- Front Panel Board Cable 33
- Left PCI Riser Card 36
- Replacement Instructions 40
- Optical Drive Cable 47
- Front Panel Board 60
- Locking Mechanism Rod 62
- Drive Interconnect Backplane 67
- Apple Drive Modules 69
- Power Distribution Board 83
- Processor Heat Sink 100
- Replacing the Airow Duct 108
- Closing the Xserve 109
- Logic Board 111
- Thumbscrews 112
- Power Supplies 114
- FB-DIMMs 115
- Airow Duct 116
- Fan Array 117
- Processor Heat Sinks 119
- Processor 122
- Replacing the Processors 132
- Replacing the Fan Array 137
- Replacing the FB-DIMMs 138
- Replacing the Power Supplies 139
- Rear ID Tab 142
- Captive screws 145
- Replacing the Logic Board 159
Produits connexes et manuels pour Logiciel Apple Xserve (Early 2008) DIY Procedure for Enclosure
Logiciel Apple iDVD 5 Manuel d'utilisateur
(38 pages)
(38 pages)
Logiciel Apple Shake 4 Manuel d'utilisateur
(105 pages)
(105 pages)
(112 pages)
(8 pages)
Logiciel Apple iWork '08 Manuel d'utilisateur
(138 pages)
(138 pages)
Melissa 635-073 manuali
Manuali dei proprietari e guide per l'utente per Asciugacapelli Melissa 635-073.
We fornisce 1 manuali pdf Melissa 635-073 per scaricare gratuitamente in base al tipo di documento: Manuale Utente
Commentaires sur ces manuels